Electrical permit history — 2525 E Prince Rd

Electrical Property Screening Report · Home

2525 E Prince Rd

A screening report for electrical planning, assembled from public-record indicators. It is not an official record and every figure in it should be verified against the issuing agency before it is relied on.

Verify parcel data at official source ↗

Build year not published — permits on file from 1999 · last permitted panel/service work 2015 (finaled) · HVAC 2020 (finaled); a newer 2025 permit is issued

Permanent link: Electrical permit history for 2525 E Prince Rd (aztucsonelectricalsolutions.com/property/112012160/2525-e-prince-rd-tucson-az-85716) · Public records last checked 2026-08-22

Is it time to upgrade?

• Electrical service & panelFinaled permit foundLast permitted 2015 (11 years ago). Worth reading the permit itself: it names the service but does not read as an increase in capacity, so this may have been a like-for-like replacement rather than an upgrade. T15CM01790 — REPLACE 125 AMP MAIN BREAKER FOR TOWNHOUSE - TEP METER CHANGEOUT PROGRAM (APA)
• Heating & coolingFinaled permit foundA newer 2025 permit for the same system is recorded as “Issued” — The work was permitted, but final completion is not confirmed. The permit description states “3 ton gas package unit changeout on the roof”. Last permitted 2020 (6 years ago). Cooling equipment works harder in Tucson than almost anywhere, so 12 to 15 years is a realistic service life rather than the 15 to 20 the industry quotes. T20CM06450 — REPLACEMENT OF A/C UNIT
• Water heaterLikely dueLast permitted 2013 (13 years ago). T13CM03013 — REPLACE WATER HEATER
• RoofNot in this windowNothing in the permit records we read for this parcel that names this system.
• Plumbing work on recordNot in this windowNothing in the permit records we read for this parcel that names this system. Unremarkable — plenty of buildings never need a permitted plumbing repair.

A found permit means a lot. A missing one means less. We read the City of Tucson’s own permit file, not a recent extract of it — back to about 2006, and into the 1990s on properties with that much history. Microfiche before then was never fully digitized. Every record links to the city’s official file. A blank line does not say nothing was done: work gets done without permits all the time. The only way to know what is actually installed is to look at it.

What that usually means electrically

• Era-based check

  A finaled 2015 panel/service permit is on record for this parcel, which makes it unlikely the original 200 A equipment is still in place. That is a permit record, not an inspection — verify the installed rating and the panel brand on site before sizing anything new. The permit record does not confirm this; an on-site inspection is required.

• Era-based check

  AFCI protection did not enter the code until the 1999 NEC (bedroom circuits, effective 2002) and was not expanded to most living areas until 2008 — so houses from the earlier part of this range typically have none at all. The permit record does not confirm this; an on-site inspection is required.

• Worth confirming

  Solar was permitted here in 2017. That means there is an existing interconnection, and the main breaker and busbar rating already carry a PV backfeed — so anything else you add (an EV charger, a heat pump) has to be checked against what is left under the 120% rule, not against the service size alone.

• Worth confirming

  There is an electrical reconnect permit from 2014. The service was disconnected at some point and brought back — usually after a vacancy, a utility disconnect, or work that required the power off. Worth knowing what prompted it.

• Routine

  A trade permit was pulled in 2020. Trade permits cover electrical, plumbing, and mechanical work individually, so some permitted trade work has been done here since.

What to check at the panel

Everything above is read off public records. These are the things only someone standing at the panel can settle, and they take about a minute. Check them against the rating the permit above describes rather than against the era — the permit is the better evidence, and neither one is an inspection.

1. The number stamped on the main breaker handle — 100, 125, 150, 175 or 200. That is the service rating, and no record on this page confirms it.
2. The busbar rating printed on the panel label. It is a different number from the main breaker, and it is the one that decides how much solar a panel can take under the 120% rule.
3. The manufacturer and catalog number on the label inside the door.
4. How many full-size spaces are left, how many positions the label permits a tandem breaker in, and the tandem limit the label states. A full panel is a different job from a full service.
5. The conductor material at the main lugs, and whether the terminations look clean and tight.
6. Whether there is a separate meter-main outside as well as the panel indoors — that changes where a disconnect and any new feeder would land.
7. Whether the water heater, dryer and range are gas or electric. No public record carries fuel type, and it is the single biggest variable in a load calculation — it can move the calculated load on the same house by more than 40 A.

Solar potential

The county’s building-footprint layer maps ≈ 3,134 sq ft of roof plan area here. In Tucson a rooftop array produces about 1,645 kWh per installed kW per year (PVWatts), so a typical 6–8 kW home system fits on a fraction of that roof and makes roughly 10,000–13,000 kWh a year. TEP credits exported surplus at its RCP rate — about 5¢/kWh for new applications, locked for 10 years — so sizing to the home’s own use matters more than filling the roof. If solar shows in this property’s permit record, check whether it was permitted and finaled.

The record behind this read

Parcel

112012160

Year constructed

1999 (earliest permit on file)

Permitting authority

Tucson

Zoning

R-2

Estimated electrical service era

approximately 200 A (estimated from the year built, 1999 — not a measurement; verify on site)

Service on record

City records show the 2015 permit was finalized; the permit description states “REPLACE 125 AMP MAIN BREAKER FOR TOWNHOUSE - TEP METER CHANGEOUT PROGRAM (APA)”.

The most recent permitted work on this parcel was in 2025. That says the parcel was worked on under permit, not what the work covered — a roof, a pool or a changeout tells you nothing about the electrical service. Work done without a permit leaves no trace here at all.

This is an inference from public records — the year a structure was built, how it is classified, and what has been permitted. It is not an inspection, and nothing here confirms what is actually installed at this address. The only way to know is to look in the panel. See an error in this public-record report? Report a correction · About this data.

Utility and upgrade pathElectric service here is Tucson Electric Power (TEP). A service or panel upgrade needs a TEP meter release and has to meet TEP’s service requirements — meter height and location, clearances, and the point of attachment. See TEP new-service requirements and the TEP standards notes.

In the public record: All homes in 85716 · Homes by ZIP code · Commercial property in 85716 · Permit data by neighborhood

The contractor’s read is a plain-English brief of the record above, written by AI — what it shows across electrical, mechanical and the building itself, what is missing for the era, and what to verify on site.

What the flood note is not. The flood zone shown is FEMA’s National Flood Hazard Layer — the federal insurance map. Local floodplain mapping is not reproduced here; use the authority’s own map, linked above. Nothing here is a floodplain determination, an elevation certificate, or a substitute for one. A parcel can straddle a boundary, and a Letter of Map Amendment can remove a structure the map still covers. For a determination, ask the floodplain administrator for the jurisdiction named above; for a design that has to satisfy one, that is work we do.