Electrical permit history — 550 S Camino Seco

Electrical Property Screening Report · Multifamily property

550 S Camino Seco

A screening report for electrical planning, assembled from public-record indicators. It is not an official record and every figure in it should be verified against the issuing agency before it is relied on.

Verify parcel data at official source ↗

Built 1985 — 1980s multifamily stock · last permitted panel/service work 2012 (finaled); a newer 2025 permit is expired without a final · HVAC 2025 (permit expired without a confirmed final) · 1 open code case

Permanent link: Electrical permit history for 550 S Camino Seco (aztucsonelectricalsolutions.com/property/13409013b/550-s-camino-seco-tucson-az-85710) · Public records last checked 2026-09-22

Is it time to upgrade?

• Electrical service & distributionFinaled permit foundA newer 2025 permit for the same system is recorded as “Expired” — The permit expired without a confirmed final status. The permit description states “Replace HVAC System - Like for Like 1.5 ton system using existing electrical service”. Last permitted 2012 (14 years ago). Worth reading the permit itself: it names the service but does not read as an increase in capacity, so this may have been a like-for-like replacement rather than an upgrade. Separately from replacement: NFPA 70E expects the arc-flash study to be reviewed at least every five years, or after any change to the service. T12CM06753 — REPLACE 100AMP MAIN BREAKER (APA)
• Heating, cooling & mechanicalPermitted — completion not confirmedA 2025 permit specifies this work (the permit description states “550 S Camino Seco Tucson, AZ 85710 Unit 1114 Scope of Work: Replace like for like HVAC system. 1.5 ton condenser and air handler. Condensing unit replacement on roof – same size / weight. 153 lbs Air handler in apartment – ceiling mount. Using existing electrical connections – Complex does not have current service outlets on roof due to 1985 build.”), but the available record does not show a final inspection. The permit expired without a confirmed final status. Official status: Expired. The assessor records cooling as WARMED AND COOLED AIR and heating as Forced Air (assessor characteristics can lag permitted work). TC-COM-0525-00887 — 550 S Camino Seco Tucson, AZ 85710 Unit 1114 Scope of Work: Replace like for like HVAC system. 1.5 ton condenser and air handler. Condensing unit replacement on roof – same size / weight. 153 lbs Air handler in apartment – ceiling mount. Using existing electrical connections – Complex does not have current service outlets on roof due to 1985 build.
• Fire alarm & life safetyFinaled permit foundLast permitted 2022 (4 years ago). Panels and devices age out on their own schedule, and the code moves underneath them — a system that was compliant when installed is not automatically compliant now. TF-FCP-1122-00105 — Replacing existing fire alarm devices with like addressable devices.
• RoofNot in this windowNothing in the permit records we read for this parcel that names this system. The assessor records the roof as Composition Shingle. Roof age matters electrically too: it sets what can be penetrated for new rooftop units, conduit, or solar.

A found permit means a lot. A missing one means less. We read the City of Tucson’s own permit file, not a recent extract of it — back to about 2006, and into the 1990s on properties with that much history. Microfiche before then was never fully digitized. Every record links to the city’s official file. A blank line does not say nothing was done: work gets done without permits all the time. The only way to know what is actually installed is to look at it.

What that usually means electrically

• Era-based check

  A finaled 2012 panel/service permit is on record for this parcel, which makes it unlikely the original 100–150 A equipment is still in place. That is a permit record, not an inspection — verify the installed rating and the panel brand on site before sizing anything new. The permit record does not confirm this; an on-site inspection is required.

• Era-based check — high priority

  Distribution gear this age is frequently past the point where the manufacturer still supports it. Breakers and fusible switches for obsolete lines can carry long lead times, which turns an outage into a shutdown. The permit record does not confirm this; an on-site inspection is required.

• Worth looking at

  There is an open code enforcement case on this parcel. An open case can hold up a permit, and if it touches unpermitted work the electrical scope usually has to be brought up to code as part of resolving it.

• Worth confirming

  Multifamily property. House panels, unit meters, and common-area loads are usually metered and maintained separately — worth confirming which side of the meter a problem falls on before scheduling work.

• Era-based check

  NFPA 70E expects arc-flash studies to be reviewed at least every five years, or after any change to the service. Buildings this age often have labeling that no longer matches the installed gear. The permit record does not confirm this; an on-site inspection is required.

• Worth confirming

  There is an electrical reconnect permit from 2016. The service was disconnected at some point and brought back — usually after a vacancy, a utility disconnect, or work that required the power off. Worth knowing what prompted it.

• Routine

  A trade permit was pulled in 2015. Trade permits cover electrical, plumbing, and mechanical work individually, so some permitted trade work has been done here since.

Solar and energy potential

Roof footprint

≈ 45,976 sq ft (county building-footprint layer, 7 structures)

Usable for solar, planning estimate

≈ 32,200 sq ft (~70% after setbacks, rooftop equipment and access paths)

Array that could fit

on the order of 350 kW — roughly 880 panels (low-tilt ballasted rows, 400 W class modules)

Estimated annual production

≈ 580,000 kWh (PVWatts, Tucson sun, low-tilt south)

Energy-charge offset at TEP commercial rates

$46,000–$75,000 a year (8–13¢/kWh energy + power-supply charges, by season and rate class)

Planning-level arithmetic on the roof area above — not a shading study, a structural review or a design. The offset assumes the building uses the power as it is generated; TEP pays far less (its export rate is about 5¢/kWh) for surplus sent to the grid, so the load profile decides the real value. The 30% federal credit (§48E) still applies to commercial systems placed in service by the end of 2027 — projects that began construction by July 4, 2026 have longer; confirm timing with a tax adviser.

TEP grid capacityThis parcel is not inside any of the 11 areas TEP has mapped as saturated with distributed generation (the nearest, “Irvington and Houghton”, is about 2.5 miles away — TEP’s map set, July 2020). New generation still goes through TEP’s interconnection screens, and a heavy new load still merits a utility capacity check — the maps only mark where that review is most likely to bite.

Get a commercial solar & switchgear analysis

The record behind this read

Parcel

13409013B

Year constructed

1985 (assessor record)

Permitting authority

Tucson

Zoning

R-3

Property type

Apartments 100+ Units 2 Story

Building area

108,144 sq ft

Cooling

WARMED AND COOLED AIR

Heating

Forced Air

Service on record

City records show the 2012 permit was finalized; the permit description states “REPLACE 100AMP MAIN BREAKER (APA) ”.

The building area, cooling and heating above come from the Pima County Assessor’s record, as we read it on 28 Jan 2026. Each other row names its own source.

The most recent permitted work on this parcel was in 2025. That says the parcel was worked on under permit, not what the work covered — a roof, a pool or a changeout tells you nothing about the electrical service. Work done without a permit leaves no trace here at all.

This is an inference from public records — the year a structure was built, how it is classified, and what has been permitted. It is not an inspection, and nothing here confirms what is actually installed at this address. The only way to know is to look in the panel. See an error in this public-record report? Report a correction · About this data.

Utility and upgrade pathElectric service here is Tucson Electric Power (TEP). A service or panel upgrade needs a TEP meter release and has to meet TEP’s service requirements — meter height and location, clearances, and the point of attachment. See TEP new-service requirements and the TEP standards notes.

In the public record: All multifamily property · Commercial property in 85710 · Commercial & industrial reports · Homes in 85710 · Permit data by neighborhood

The contractor’s read is a plain-English brief of the record above, written by AI — what it shows across electrical, mechanical and the building itself, what is missing for the era, and what to verify on site.

What the flood note is not. The FEMA map linked above is the National Flood Hazard Layer — the federal insurance map. Local floodplain mapping is not reproduced here; use the authority’s own map, linked above. Nothing here is a floodplain determination, an elevation certificate, or a substitute for one. A parcel can straddle a boundary, and a Letter of Map Amendment can remove a structure the map still covers. For a determination, ask the floodplain administrator for the jurisdiction named above; for a design that has to satisfy one, that is work we do.