Electrical permit history — 1830 W Copper St

Commercial property

1830 W Copper St

Built 1993 — 1990s commercial stock · last permitted panel/service work 2025 (permitted, completion not confirmed)

Permanent link: Electrical permit history for 1830 W Copper St (aztucsonelectricalsolutions.com/property/10703134a/1830-w-copper-st-tucson-az-85745) · Public records last checked 2026-08-16

Parcel

10703134A

Built

1993 (assessor record)

Jurisdiction

Tucson

Zoning

I-1

Assessor use

Warehousing

Parcel size

1.45 acres

Building area

25,100 sq ft (assessor record)

Sewer

No connection on file (sewer or septic status not confirmed by the record — verify on site)

Flood zone

X — minimal flood hazard (FEMA)

Historic preservation

Not on file (City of Tucson HP layers)

Service on record

A 2025 permit was issued; completion is not confirmed in the available record; the permit description states “3 phases, Like for Like main breaker swap out at SES. 2500amp breaker Building loses power daily, need to replace the breaker.”.

See the property

Pima County orthophoto (Pictometry 2024 / PAG 2023 / NAIP 2023 mosaic) — parcel outlined in yellow. Aerials can predate recent work and show nothing about what is inside; context, not evidence.

Street ViewGoogle Maps satelliteGoogle Earth (3D, historical imagery) ↗

Is it time to upgrade?

• Electrical service & distributionPermitted — completion not confirmedA 2025 permit specifies this work (the permit description states “3 phases, Like for Like main breaker swap out at SES. 2500amp breaker Building loses power daily, need to replace the breaker.”), but the available record does not show a final inspection. The work was permitted, but final completion is not confirmed. Official status: Inspections. City inspection record: last recorded inspection 2025-10-10; no approved final is shown. TC-COM-0925-01643 — 3 phases, Like for Like main breaker swap out at SES. 2500amp breaker Building loses power daily, need to replace the breaker.
• Heating, cooling & mechanicalNot in this windowNothing in the permit records we read for this parcel that names this system. Packaged rooftop units work harder in Tucson than almost anywhere, so 12 to 15 years is a realistic service life rather than the 15 to 20 the industry quotes. Worth confirming from the equipment nameplate rather than the record. Replacing a rooftop unit is also an electrical question: the new unit's minimum circuit ampacity and its disconnect often differ from the old one.
• Fire alarm & life safetyPermitted — completion not confirmedA 2018 permit specifies this work (the permit description states “Fire Alarm & Detection Systems - communicator installation; Fire Alarm Systems - Monitor Only; Work Started Without Approved Permit”), but the available record does not show a final inspection. The permit expired without a confirmed final status. Official status: Expired. T18FC00436 — Fire Alarm & Detection Systems - communicator installation; Fire Alarm Systems - Monitor Only; Work Started Without Approved Permit
• RoofNot in this windowNothing in the permit records we read for this parcel that names this system. Roof age matters electrically too: it sets what can be penetrated for new rooftop units, conduit, or solar.

A found permit means a lot. A missing one means less. We read the City of Tucson’s own permit file, not a recent extract of it — back to about 2006, and into the 1990s on properties with that much history. Microfiche before then was never fully digitised. Every record links to the city’s official file. A blank line does not say nothing was done: work gets done without permits all the time. The only way to know what is actually installed is to look at it.

What that usually means electrically

• Era-based check

  Gear in this age range is usually still supported but is due for infrared scanning and torque verification if that has not been done recently. The permit record does not confirm this; an on-site inspection is required.

• Era-based check

  NFPA 70E expects arc-flash studies to be reviewed at least every five years, or after any change to the service. Buildings this age often have labeling that no longer matches the installed gear. The permit record does not confirm this; an on-site inspection is required.

• Worth confirming

  A pool or spa was permitted in 2020. Pool equipment brings its own bonding grid, GFCI requirements, and usually a subpanel — and the bonding rules have tightened since, so older installations are worth verifying.

Most recent permit on record for this parcel: 2025-09-08 (TC-COM-0925-01643) — 3 phases, Like for Like main breaker swap out at SES. 2500amp breaker Building loses power daily, need to replace the breaker..

Permit history (5)

How to read the status column: Final / Complete / C of O — city records show the permit was finalized. Issued — the work was permitted, but final completion is not confirmed. Applied / In review / Approved / Fees paid — proposed, not completion. Expired — the permit expired without a confirmed final status. Void / Withdrawn / Canceled — not evidence the work was installed. Any other status is shown exactly as the issuing office records it, without a completion reading.

Record numbers link to the City of Tucson’s official file. Highlighted rows are the ones that imply electrical work or an unpermitted-work finding.

This is an inference from public records — the year a structure was built, how it is classified, and what has been permitted. It is not an inspection, and nothing here confirms what is actually installed at this address. The only way to know is to look in the panel. See an error in this public-record report? Report a correction · About this data.

The contractor’s read is a plain-English brief of the record above, written by AI — what it shows across electrical, mechanical and the building itself, what is missing for the era, and what to verify on site.